On-site mobile concrete plant MOBILE-45, with a capacity of up to 45 m³ of concrete per hour of work.

Carriage in a 40 ton container or eurowaggon.

---

The plant is supplied already fully ready for use, does not require any makeready, checkout or foundation construction.
It is set in the open air, any dense surface without preparation or any room with a ceiling height of at least 5 meters.

---

Start-up: connection to 380 V voltage supply and water feed. It takes less than two hours!

---

The principle of automatic operation:

• Inert materials (sand, screenings, crushed rock, etc) that will be used for concrete production are loaded into the hoppers in accordance with their naming. There are 2 hoppers for inert materials. Cement, water and chemical additives are distributed the same way.
• After selecting a specific concrete recipe, the required volume (m³) is entered. After that, the plant starts production.
• Inert materials are batched separately according to set weight. The batching is performed on the belt conveyor on which they are fed by opening of the hopper's gate.
• Dosed inert by means of a weight conveyor are fed into the concrete mixer.
• Cement, water and various chemical additives are fed to the corresponding dispensers where they are weighted according to the formula specified in the automation system.
• After batching all concrete components are loaded in turns into the mixer through the dispensers' gates.
• The mixture of all components is mixed in the mixer double shaft for a certain time and as a concrete solution is supplied through the drain valve mixer.

---

Twin-shaft mixer BP-2T-750.

---

Объем 750 литров. Бетоносмеситель принудительного типа, двухвальный. С горизонтальным расположением валов. Общее количество лопастей – 14. Мощность привода смесителя 11 кВт. Вращение валов с частотой 36 оборотов в минуту.

6 mm thick paddles made of wear-resistant cast iron, adjustable for gap aligning.

The armor is also made of wear-resistant cast iron 10 mm thick, replaceable, bolted. Warranty period before wear is at least 2 years or 40,000 m³ of concrete.

Unloading is done through a pneumatic seal.

In one cycle, 0.5 m³ of concrete is produced. The cycle lasts about 40 seconds. Thus, 1 m³ of concrete is produced in one and a half minutes of plant operation. MOBIL-45.

---

ZZBO is the official dealer of SICOMA concrete mixers in Russia and the CIS!
It is possible to supply a concrete plant with a concrete mixer from the manufacturer SICOMA.

---

Doziruûŝij bunker DK-24th

---

It has a large capacity of 24 m³ of inert materials. These are two bunkers with a volume of 12 m³.
Big loading hoppers width - 3 meters
The conveyor is equipped with chevron belt and lined drum.
Weighing conveyor, on suspended strain gauges. Dosage error 1%. Conveyor drive power 11 kW.
The hoppers are equipped with two Camozzi pneumatic gate valves and two MVE 300/3 vibrators.

---

Dozatorov block DB-30.

---

Consists of three components: cement dispenser, water dispenser and chemical additives dispenser.
The 300 kg cement dispenser is equipped with a pneumatic damper and an MVE 300/3 shaker vibrator. The weight dispenser is located on three strain gauges.
Weighing water dispenser for 150 liters, with three high-precision strain gauges.
Chemical additives dispenser is made of stainless steel. Water and chemical additives dispensers are equipped with pneumatically operated gates.

---

PAM remote control

---

Work on the principle of pressing one button, select the brand of concrete - the amount of concrete and press the start of the cycle! Controller and touch graphic control panel.

Productivity 45 m³ / h for ready-made concrete (in continuous operation, with recipes with 2 aggregate components, 1 binder component (its maximum mass is 300 kg per 1 m³ of concrete), with normal fluidity, 5% sand moisture, water / cement ratio equal to 0.5, with 30 seconds stirring and positive ambient temperature.

Issuance of ready mix - tub.

Technical Features