On-site mobile concrete plant MOBILE-20, capacity - 20 cubic meters of concrete per hour.

Transportation in one 20-ton container or 5-ton truck. Dimensions: length - 4.4 meters, width - 2 meters, height in transport position - 2.4 meters. Weight - 4 tons.

The plant is supplied already fully ready for use, does not require any makeready, checkout or foundation construction.
Installed on an open area, on any dense surface or in a workshop minimum 4 meters height.

Start-up: connection to 380 V voltage supply and water feed. It takes less than two hours!

The principle of automatic operation:

• Inert materials (sand, screenings, crushed rock, etc) that will be used for concrete production are loaded into the hoppers in accordance with their naming. There are 2 hoppers for inert materials. Cement, water and chemical additives are distributed the same way.
• After selection of a particular concrete formula, there needed to input the required volume (m³). After this the process of production starts.
• Inert materials are batched separately according to set weight. The batching is performed on the belt conveyor on which they are fed by opening of the hopper's gate.
• Batched inert materials are loaded into the mixer on this weigh belt conveyor.
• Cement, water and various chemical additives are fed to the corresponding dispensers where they are weighted according to the formula specified in the automation system.
• After batching all concrete components are loaded in turns into the mixer through the dispensers' gates.
• All components are mixed in the mixer during certain time period and after that ready-mix concrete/mortar is discharged through the mixer's dump gate.

BP-1G-500 single-shaft concrete mixer

Volume 500 liters. Positive concrete mixer with one horizontal shaft. 6 paddles for mixing. 11 kW drive. Rotation speed - 30 rot/min.

6 mm thick paddles made of wear-resistant cast iron, adjustable for gap aligning.

The armor is also made of wear-resistant cast iron 10 mm thick, replaceable, bolted. Warranty period until wear is at least 2 years or 40,000 cubic meters of concrete.

Unloading is carried out through a pneumatic gate

One cycle lasts for less than 1 minute during which 0.33 cu m of ready-to-use concrete is produced. Thus 1 cu m is produced in three minutes.

ZZBO is the official dealer of SICOMA concrete mixers in Russia and the CIS!
It is possible to supply a concrete plant with a concrete mixer from the manufacturer SICOMA.

DK-8 Batching Complex

High capacity for inert materials storage - 8 cu m - two hoppers 4 cu m each.
Special feature - loading of the batching complex by any front-end loader from one side of the hopper.
Large hopper loading width - 2.9 meters.
Loading height only 2.8 meters, no additional ramp needed.
The conveyor is equipped with chevron belt and lined drum.
Weight conveyor, on suspended load cells. Dosing error 1%. Conveyor drive power 7.5 kW.
The hoppers are equipped with two pneumatic valves and two vibrators.

BD-15 Block of Dispensers

Consists of three components: cement dispenser, water dispenser and chemical additives dispenser.
The batcher of cement on 150 kg is supplied with the pneumatic gate, and the vibrator shaker. The weight dispenser is located on three load cells.
Weighing water dispenser for 75 liters, on three high-precision strain gauges.
Chemical dispenser made of stainless steel. The batcher of chemistry and water are supplied with the pneumatic valve for discharge of liquid.

Compressed air system compressor B5200B/200 CT4

consists of a B5200B/200 CT4 piston compressor and a pneumatic system. Capacity 530 liters per minute, power 3 kW. Pressure 10 atm. The compressor is already built into the frame and is protected from the external environment and dust.

PAM remote control

Work on the principle of pressing one button, select the brand of concrete - the amount of concrete and press the start of the cycle! Controller and touch graphic control panel.

Capacity 20 m³/hour of ready-mixed concrete (in case of continuous operation, with formulas with 2 aggregates and 1 binding agent(its maximum weight - 300 kg per 1 m³ of concrete), in case of normal flow characteristics, 5% sand moisture, 0.5 water/cement proportion, 30 seconds mixing time and above-zero temperature.

Discharge of ready mix into a bucket.

Technical Features

• Capacity, cu m per hour 10...20
• Hopper capacity, cu. m 8 (2 x 4)
• Concrete mixer BP-1G-500
• Total power, kW 27
• Voltage, V 380
• Dimensions of the basic configuration:
• Weight, kg 4,200
• Height hoppers, mm 2840
• Maximum height in the operating position, mm 3,200
• Width, mm 2214
• Length, mm 4380